MC52i AT Command Set

MC52i AT Command Set
2.13 AT^SCFG
Write Command
Configuration of URC "^SLCC" Call Status Indication
AT^SCFG="URC/CallStatus/SLCC"[, ]
Response(s)
^SCFG: "URC/CallStatus/SLCC",
OK
ERROR
+CME ERROR:
Write Command
URC indication in datamode via Ring line:
AT^SCFG="URC/Datamode/Ringline"[, ]
Response(s)
^SCFG: "URC/Datamode/Ringline",
OK
ERROR
+CME ERROR:
Write Command
URC indication via Ring line:
AT^SCFG="URC/Ringline"[, ]
Response(s)
^SCFG: "URC/Ringline",
OK
ERROR
+CME ERROR:
Write Command
Duration of active RING line for URC indications:
AT^SCFG="URC/Ringline/ActiveTime"[, ]
Response(s)
^SCFG: "URC/Ringline/ActiveTime",
OK
ERROR
+CME ERROR:
PIN ASC0 ASC1 MUX1 MUX2 MUX3 Charge Last
- + + + + + - - -
Parameter Description
(str)(+CSCS)
Adaptive Multi Rate
This parameter can be used to control the usage of the feature "Adaptive Multi Rate" (AMR). It is possible to
enable or disable this feature for all network operators, or to enable it for selected operators (max. 10). If the
feature is enabled for all operators, any request to enable it for a specific operator will result in a "+CME ERROR:
operation temporary not allowed".
Changes of this parameter become active with the next call.
Parameter is global for all interfaces, volatile and will not be reset by AT&F.
“enabled“ (P)
AMR is used for every operator.
“disabled“
AMR is not used for any operator.
00000...999999 Enable AMR for the specified operator (in BCD or IRA format; see AT+COPS).
MC52i_ATC_V01.201 Page 55 of 551 4/16/10
Confidential / Released