MC52i AT Command Set

MC52i AT Command Set
15.4 AT^SSTA
(num)
The whole RSAT handling (^SSTN, AT^SSTGI, AT^SSTR will only be active at the Instance, for which the SSTA
command was executed.
However, if the Instance should be changed, please execute AT^SSTA at the desired Instance and restart the
module for activation of the new settings.
0 SAT is already used on another instance (logical channel in case of the multiplex
protocol). Only test and read commands can be used.
1 SAT may be started on this instance via the write version of this command.
(str)
SAT profile according to GSM 11.14 [22].
The profile tells the SIM Application which features (e.g. proactive commands) are supported by the SIM Application
Toolkit implementation of the MC52i.
(num)
Select Remote SAT activation mode.
Parameter is stored non-volatile and takes effect after next restart of the ME. Removing and inserting the SIM
does not affect the activation status.
0 (D) Automatic response (AR) mode.
All commands and responses are exchanged automatically between the ME
and the SIM application. This eliminates the need to enter any Remote SAT AT
commands incl. the AT^SSTA command.
If AR mode is enabled the ME enters the OFF state (=1) after reboot.
1 Explicit response (ER) mode.
This mode is intended for use with an MMI. If ER mode is enabled the MMI is
required to handle, via the module's Remote-SAT interface, all commands and
responses transmitted to or from the SIM.
If ER mode is enabled the ME enters the IDLE state (= 2) after reboot.
MC52i_ATC_V01.201 Page 398 of 551 4/16/10
Confidential / Released