30.06.2014 Views

MC52i AT Command Set

MC52i AT Command Set

MC52i AT Command Set

SHOW MORE
SHOW LESS

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

<strong>MC52i</strong> <strong>AT</strong> <strong>Command</strong> <strong>Set</strong><br />

<br />

15.7 <strong>AT</strong>^SSTGI<br />

15.7 <strong>AT</strong>^SSTGI S<strong>AT</strong> Get Information - Refresh (1)<br />

The <strong>AT</strong>^SSTGI=1 command shall be used after receiving the URC "^SSTN: 1". This URC notifies the TE that<br />

one or more Elementary Files on the SIM have been changed as a result of a SIM application activity, usually<br />

caused by the network provider. The response to the <strong>AT</strong>^SSTGI=1 command indicates what type of SIM refresh<br />

has occurred. The change requires that the Elementary Files of the SIM be synchronized with the equivalent<br />

information (if any) stored inside the TE. Depending on the type of SIM refresh the TE may need to use the<br />

<strong>AT</strong>+CRSM command to read out the Elementary Files and store the refreshed information.<br />

The response parameters , and are mandatory if <br />

equals 1 or 2. In all other cases they are optional and can be ignored.<br />

Syntax<br />

Write <strong>Command</strong><br />

<strong>AT</strong>^SSTGI=1<br />

Response(s)<br />

^SSTGI: , [, , , ]<br />

OK<br />

ERROR<br />

+CME ERROR: <br />

PIN ASC0 ASC1 MUX1 MUX2 MUX3 Charge Last<br />

- + + + + + - - -<br />

Parameter Description<br />

(num)<br />

1 Proactive command ID, see Section 15.3, Remote-S<strong>AT</strong> <strong>Command</strong> Types and<br />

Table 15.6.<br />

(num)<br />

For every return value of other than 4 (SIM Reset) the TE shall complete the proactive<br />

command cycle using <strong>AT</strong>^SSTGI=1.<br />

0 SIM Initialization and Full File Change Notification<br />

1 File Change Notification<br />

2 SIM Initialization and File Change Notification<br />

3 SIM Initialization<br />

4 Value "4" means SIM Reset, but the value itself never appears. This is because<br />

value "4" is mapped to the URC "^SSTN: 255" which will be sent when a SIM<br />

reset occurs. In this case, the TE does not need to respond, i.e. the SIM<br />

Refresh commands <strong>AT</strong>^SSTGI and <strong>AT</strong>^SSTR are neither required nor allowed.<br />

Instead, as the SIM application restarts, the Toolkit application inside the TE<br />

should also return to initial state after receiving the URC "^SSTN: 255". For<br />

more information on SIM reset and the URC "^SSTN: 255" refer to Section<br />

15.5, S<strong>AT</strong> Notification.<br />

5...255 Reserved values<br />

(num)<br />

Number of bytes coded in <br />

<strong>MC52i</strong>_<strong>AT</strong>C_V01.201 Page 402 of 551 4/16/10<br />

Confidential / Released

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!