M800 Gas Flow Computer - Spirax Sarco
M800 Gas Flow Computer - Spirax Sarco
M800 Gas Flow Computer - Spirax Sarco
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
h<br />
b<br />
Fig. 12<br />
a<br />
h<br />
<br />
c<br />
3. Unclip the hinge 'a' by pulling the front of the hinge sideways.<br />
4. Unscrew the top and bottom self-tapping screws 'h' (concealed by hinge).<br />
5. Insert a screwdriver into the slot along the right hand hinge 'b'.<br />
6. While supporting the front 'c', prise the right hand fixed hinge 'b' open. Take care not to<br />
allow the front cover to fall.<br />
7. Remove the front section and store in a safe place.<br />
8. Slide the <strong>M800</strong> flow computer through the aperture until bezel 'd' (Figure 10) butts up<br />
against the panel front.<br />
9. Tighten the four clamping screws 'g' through the access holes in the <strong>M800</strong> front panel<br />
bezel. This will automatically extend the clamping legs 'f' (Figure 10).<br />
10. Replace the front section and clip the hinges back into position.<br />
IMPORTANT: Ensure the front section is secured at the top and bottom using the two<br />
self-tapping screws supplied 'h'. These prevent the operator from gaining access to<br />
hazardous live parts.<br />
g<br />
g<br />
g<br />
g<br />
Fig. 13<br />
IM-P333-25 MI Issue 2 15