M800 Gas Flow Computer - Spirax Sarco
M800 Gas Flow Computer - Spirax Sarco
M800 Gas Flow Computer - Spirax Sarco
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
6.3 Commissioning mode<br />
The commissioning mode is used to set the <strong>M800</strong> to the pipeline flow, temperature and<br />
pressure sensors, set and test the outputs and change the pass code.<br />
All data entry is performed via a menu and sub menu configuration with the key pad buttons<br />
used for navigation, i.e. to go deeper into the menu the right hand key is pressed, to<br />
scroll up and down the menu the up and down keys are pressed and to exit<br />
from a sub-menu the left key is pressed. The display will step down a line each time<br />
a sub-menu is entered and display the previous menu title.<br />
For example:-<br />
Commissioning mode<br />
• Basic Data<br />
Key<br />
press<br />
Commissioning mode<br />
• Basic Data<br />
• Units<br />
Key<br />
press<br />
Commissioning mode<br />
• Basic Data<br />
• Units<br />
Met<br />
Key<br />
press<br />
Commissioning mode<br />
• Basic Data<br />
• Units<br />
Imp<br />
Data to be edited is always displayed on the bottom right of the screen. Pressing the OK key<br />
will enter new data. By pressing the up and down keys, the display will scroll through the<br />
available data and the previously entered selection will flash. After a period of ten minutes<br />
without any keys being pressed, the <strong>M800</strong> will automatically return to the run mode.<br />
You can enter the commissioning mode from the run mode<br />
(apart from the error and alarm screen) by pressing and holding<br />
down the 'OK' key for 5 seconds. The display then shows: Enter pass<br />
8888<br />
The flashing leading digit indicates the position of the cursor. The default, or factory set pass<br />
code is 8888 (this can be changed from within the commissioning mode). The pass code can<br />
be entered by using the up and down keys to increment or decrement the flashing value<br />
and the left and right keys to move the cursor.<br />
Pressing 'OK' will enter the pass code. If an incorrect pass code<br />
is used, the display automatically returns to the run mode.<br />
After the correct pass code is entered the display shows:<br />
Commissioning mode<br />
• Basic Data<br />
To exit the commissioning mode at any stage, pressing and holding the left key will<br />
return the <strong>M800</strong> to the run mode.<br />
Pressing the up and down buttons scrolls through the various first level menus.<br />
Pressing the right arrow button enters a particular sub-menu.<br />
IM-P333-25 MI Issue 2 31