Software Reference Manual - NetEx

gotiated, which contains a value other than one when data is being sent to non-IBM processors with
more than one character per word.
User Response: None
BFX313W NETEX down-BFXJS will wait $$ sec and reoffer.
Severity: 12 (Severe)
Module: BFXJS
Explanation: This message is issued by BFXJS when it has attempted to offer itself but received a
return code of 500 or 505 (NETEX down or being drained). “$$” is the number of seconds that it will
wait before attempting the offer again
User Response: Cancel BFXJS, start NETEX, or do nothing - JS will continue to offer itself.
BFX314I BFXJS: Job Submitted.
Severity: 12 (Detailed information, but should be sent to the operator)
Module: BFXJSC in program BFXJS.
Explanation: The BFXJS program has submitted a job.
User Response: None
BFX315W Char Mode Record Truncated To 9999 Bytes.
Severity: 9 (Warning)
Module: BFXSBM in program BFXTI or BFXTR.
Explanation: A record greater than 9999 bytes in length was encountered during a char mode transfer.
The record is truncated.
User Response: Transfer the file in BIT mode or allow the truncation to occur.
BFX316I sb rjobname rjobid rhost – “message from remote job status responder (BFXJSTAT).”
Severity: 9 (Highly visible)
Module: BFXCON in program BFXTI
Explanation: BFXTI was not connected to by BFXTR. The user specified the “RMTJOB” parameter
in order to use the remote job status facility on the Z/OS remote host to determine the status of the
BFXTR job. The status may be as follows:
sb = 0 Job not executing or queued for output.
sb = 1 Remote job is executing or queued for execution.
sb = 2 Could not Connect to 'Job Status Responder; no job status available.
The “rjobname” is the BFXTR jobname from the “RMTJOB” parameter (JOBSTAT if sb = 2). The
“rjobid” is the JES jobid returned from B FXJSTAT. The “rhost” is the remote host name for the
BFXTR job. The following messages may be returned by BFXJSTAT.
CURRENTLY ACTIVE
Job is running.
WAITING FOR EXECUTION Job is waiting to run.
QUEUED FOR OUTPUT
Job has already run; possible JCL error.
HOLDING
Job is queued for execution.
ACTIVE IN NJE
Job is in the process of being transferred to another node.
STATUS UNKNOWN
JES returned unknown condition.
JOB NOT FOUND
Possible JCL error; probably already flushed.
DISASTROUS ERROR
JES is terminating for unknown reason. This should be
shown to the systems programmer.
RCxxxx SCONNECT to BFXJSTAT FAILED Interrogate the NRBSTAT in Rcxxxxx to
determine the cause of the problem.
User Response: If the message indicates that the remote job will never connect to BFXTI, determine
the cause of the problem, correct it and run the job again. Refer to "Messages Issued by the Job
Status Function" on page 32 for more messages and descriptions.
MAN-REF-H211-05 Appendix C: BFX Error Messages Page 107