Software Reference Manual - NetEx

SAMPACCT Default value:
‘’(none)
Allowed values: '' or any valid job accounting information
The SAMPACCT parameter is used to provide job card accounting information for the BFX
sample job.
Example:
SAMPACCT(1234)
SAMPNTFY Default value: '' (none)
Allowed values: '' or any valid TSO user ID
The SAMPNTFY parameter is used to provide the TSO user ID that will be notified when the
BFX sample job completes. To remove the NOTIFY keyword from the sample BFX job card,
specify this parameter as:
Example:
SAMPNTFY('')
SAMPNTFY(USER1)
BFXINST Installation Parameters (Copy Phase):
PROCLIB Default value: (None)
Allowed values: '' or any valid fully qualified data set name
The PROCLIB parameter is used to provide the fully qualified name of the JCL procedure library
data set that will contain the BFXJS startup procedure, as specified by the BFXPROC
parameter. The EDIT phase creates the started task JCL procedure and the COPY phase copies
it into your specified JCL procedure library for later activation. To bypass the copy of the
JCL procedure, either do not execute the COPY phase of the installation job, or specify this
parameter as:
Example:
PROCLIB('')
PROCLIB(SYSP.BFX.PROCLIB)
REPLACE Default value: NO
Allowed values: YES NO
The REPLACE parameter is used to determine whether or not existing members in the dataset
specified by PROCLIB will be replaced during the COPY phase.
Note: If the BFXJS proc name specified by BFXPROC already exists in the PROCLIB dataset
specified by PROCLIB, be sure to specify REPLACE(YES).
Example:
REPLACE(YES)
MAN-REF-H211-05 Installing BFX Page 51