Software Reference Manual - NetEx

Appendix E. BFX Condition Codes
After execution of BFX, the user may check for condition codes. These condition codes indicate the status of
the job. The user may construct the JCL to continue, restart, or terminate BFX on the basis of the returned
codes.
The condition codes are in the form of one or two-digit numbers and have the following meanings:
Code Meaning
0 The job was completed.
4 The job was completed, but informational messages were issued. Access the messages in the BFX
job log.
8 The job was completed, but warning messages were issued. Access the messages in the BFX job log.
12 A fatal error occurred, and the job was not completed. Consult the job log for causes.
16 A fatal error occurred, and the job was not completed. Usually the connection failed.
20 A fatal error occurred, and the job was not completed. NETEX may be drained or not up, or the user
may not be authorized to use NETEX.
24 A condition occurred (for example, a HALT SREF command was issued) which caused the BFX job
to terminate.
MAN-REF-H211-05 Appendix E: BFX Condition Codes Page 111