Software Reference Manual - NetEx

The VOLUME parameter is used to provide the z/OS volume name which will be used to allocate
the H211 installation data sets.
Note: If an SMS policy is in effect for the HLQ name specified, the UNIT and VOLUME parameters
can be omitted.
Example:
VOLUME(PROD01)
UNIT Default value: ‘’ (none)
Allowed values: Any valid direct access (DASD) unit name
The UNIT parameter is used to provide the z/OS unit name which will be used to allocate the
H211 installation data sets.
Note: If an SMS policy is in effect for the HLQ name specified, the UNIT and VOLUME parameters
can be omitted.
Example:
UNIT(SYSDA)
BFXINST Installation Parameters (Link Phase):
ASSEMBLE Default value: ASMA90
Allowed values: Any valid z/OS program name
The ASSEMBLE parameter is used to provide the name of the IBM Assembler program at
your site. This name is usually "ASMA90".
Example:
ASSEMBLE(ASMA90)
If the Assembler does not reside in data set SYS1.LINKLIB at your site, the ASMLOAD parameter
must be added to the installation job following the ASSEMBLE parameter. Its value
should be the name of the data set at your site that contains the program specified in the
ASSEMBLE parameter.
Example:
ASMLOAD(SYSP.LINKLIB)
LINKEDIT Default value: IEWL
Allowed values: Any valid z/OS program name
The LINKEDIT parameter is used to provide the name of the IBM Linkage Editor or Binder
program at your site. This name is usually "IEWL".
Example:
LINKEDIT(IEWL)
If the Linkage Editor or Binder program does not reside in data set SYS1.LINKLIB at your
site, the LINKLOAD parameter must be added to the installation job following the
LINKEDIT parameter. Its value should be the name of the data set at your site that contains
the program specified in the LINKEDIT parameter.
Example:
LINKLOAD(SYSP.LINKLIB)
Page 36 Installing BFX MAN-REF-H211-05