QLogic OFED+ Host Software User Guide, Rev. B

D–SRP Configuration
QLogic SRP Configuration
Specifying a SRP Target Port of a Session by IOCGUID
The following example specifies a target by IOC GUID:
session
begin
card: 0
port: 1
targetIOCGuid: 0x00066A013800016c #IOC GUID of the InfiniFibre port
end
• 0x00066a10dd000046
• 0x00066a20dd000046
Specifying a SRP Target Port of a Session by Profile String
The following example specifies a target by Profile String:
Specifying an Adapter
session
begin
card: 0
port: 1
# FVIC in Chassis 0x00066A005000010E,
# Slot number 1, port 1
targetIOCProfileIdString: “FVIC in Chassis 0x00066A005000010E, Slot 1, IOC 1”
end
An adapter is a collection of sessions. This collection is presented to the Linux
kernel as if the collection was a single Fibre Channel adapter. The host system
has no information regarding session connectivity. It only sees the end target fibre
channel devices. The adapter section of the qlgc_srp configuration file contains
multiple parameters. These parameters are listed in the adapter section of the
ib_qlgc_srp_build_cfg script system output shown in “Determining the values
to use for the configuration” on page D-6 The following example specifies an
adapter:
adapter
begin
description: “Oracle RAID Array”
end
Restarting the SRP Module
For changes to take effect, including changes to the SRP map on the VIO card,
SRP will need to be restarted. To restart the qlgc_srp driver, use the following
command:
/etc/init.d/qlgc_srp restart
D-10 D000046-005 B