QLogic OFED+ Host Software User Guide, Rev. B

F
Troubleshooting
This appendix describes some of the tools you can use to diagnose and fix
problems. The following topics are discussed:
• Using LEDs to Check the State of the Adapter
• BIOS Settings
• Kernel and Initialization Issues
• OpenFabrics and InfiniPath Issues
• System Administration Troubleshooting
• Performance Issues
• QLogic MPI Troubleshooting
Troubleshooting information for hardware installation is found in the QLogic
InfiniBand Adapter Hardware Installation Guide and software installation is found
in the QLogic Fabric Software Installation Guide.
Using LEDs to Check the State of the Adapter
The LEDs function as link and data indicators once the InfiniPath software has
been installed, the driver has been loaded, and the fabric is being actively
managed by a subnet manager.
Table F-1 describes the LED states. The green LED indicates the physical link
signal; the amber LED indicates the link. The green LED normally illuminates first.
The normal state is Green On, Amber On. The QLE7240 and QLE7280 have an
additional state, as shown in Table F-1.
Table F-1. LED Link and Data Indicators
Green OFF
Amber OFF
LED States
Indication
The switch is not powered up. The software is neither
installed nor started. Loss of signal.
Verify that the software is installed and configured with
ipath_control -i. If correct, check both cable connectors.
D000046-005 B F-1