QLogic OFED+ Host Software User Guide, Rev. B

3–TrueScale Cluster Setup and Administration
IB Bonding
The following is an example for ib0 (slave). The file is named
/etc/sysconfig/network-scripts/ifcfg-ib0:
DEVICE='ib0'
BOOTPROTO='none'
STARTMODE='off'
WIRELESS='no'
ETHTOOL_OPTIONS=''
NAME=''
USERCONTROL='no'
IPOIB_MODE='connected'
The following is an example for ib1 (slave 2). The file is named
/etc/sysconfig/network-scripts/ifcfg-ib1:
DEVICE='ib1'
BOOTPROTO='none'
STARTMODE='off'
WIRELESS='no'
ETHTOOL_OPTIONS=''
NAME=''
USERCONTROL='no'
IPOIB_MODE='connected'
Verify the following line is set to the value of yes in /etc/sysconfig/boot:
RUN_PARALLEL="yes"
Verify IB Bonding is Configured
After the configuration scripts are updated, and the service network is restarted or
a server reboot is accomplished, use the following CLI commands to verify that IB
bonding is configured.
• cat /proc/net/bonding/bond0
• # ifconfig
3-10 D000046-005 B