QLogic OFED+ Host Software User Guide, Rev. B

D–SRP Configuration
QLogic SRP Configuration
adapterDeviceRequestTimeout: 2
# set to 1 if you want round robin load balancing
roundrobinmode: 0
# set to 1 if you do not want target connectivity
verification
noverify: 0
description: "SRP Virtual HBA 0"
end
Failover Configuration File 2: Failing over from a port on the
VIO hardware card to another port on the VIO hardware card
session
begin
card: 0 (InfiniServ HCA card number)
port: 1 (InfiniServ HCA port number)
targetIOCProfileIdString: "FVIC in Chassis ,
, "
initiatorExtension: 1
end
session
begin
card: 0 (InfiniServ HCA card number)
port: 1 (InfiniServ HCA port number)
targetIOCProfileIdString: "FVIC in Chassis ,
, "
initiatorExtension: 1 (Here the extension should be different
if using the same IOC in this adapter for FVIC, so that
separate maps can be created for each session).
end
adapter
begin
description: “FC port Failover”
end
On the VIO hardware side, the following needs to be ensured:
• The target device is discovered and configured for each of the ports that is
involved in the failover.
• The SRP Initiator is discovered and configured once for each different
initiatorExtension.
• Each map should use a different Configured Device, e.g Configured Device
1 has the Target being discovered over FC Port 1, and Configured Device 2
has the Target being discovered over FC Port 2.)
D000046-005 B D-15