QLogic OFED+ Host Software User Guide, Rev. B

D–SRP Configuration
QLogic SRP Configuration
session
begin
card: 0
port: 1
targetIOCProfileIdString: "FVIC in Chassis
0x00066A005000011D, Slot 1, IOC 2"
initiatorExtension: 2
end
adapter
begin
description: "Test Device 1"
end
Configuring Fibre Channel Failover
Fibre Channel failover is essentially failing over from one session in an adapter to
another session in the same adapter.
Following is a list of the different type of failover scenarios:
• Failing over from one SRP initiator port to another.
• Failing over from a port on the VIO hardware card to another port on the VIO
hardware card.
• Failing over from a port on a VIO hardware card to a port on a different VIO
hardware card within the same virtual I/O chassis.
• Failing over from a port on a VIO hardware card to a port on a different VIO
hardware card in a different virtual I/O chassis.
D000046-005 B D-13