SetEditFDU-HD for FDU-receiver and compatible Contents:

You can change all colours in the configuration menu.
In the lower left corner you will find an "Information" section, where you see the parameters of a
selected transponder or channel.
When you select a satellite in the satellite list only the transponders and channels that are in that
satellite are shown. When you click in a transponder or favourite list only the channels that are in this
list are shown.
You can adapt the design of SetEditFDU-HD to your personal wishes.
To change the size of the main window you can either click on the maximise button in the upper right
corner or drag one of the margins of the window.
If the main window is large enough, the channel lists can be shown in more than one column. Then
you have more channels in view. You can change the width of these columns in the configuration
menu on the tab sheet "General settings". In the section "Column width" you can enter if a new column
is created, when 100% (auto) or 90-30% of the channels are shown completely. The other channel
names are cut.
With "manual" you can enter the column width by hand. Select the function "Setup column width" from
the menu of the channel lists and then you can click on the position where you want to have the right
border of the first column.
Note: There is a minimum width for the columns. If the window is too small to show more than one
column the column width has no effect.
In the section "Cut names" you can enter if the channel name is cut at the end,
or if a part of the channel name is cut from the middle.
In the configuration on the tab sheet "General settings" you can change the menu language of SetEdit
(this concerns all opened SetEdit windows) and specify whether the PIDs are shown in decimal or
hexadecimal form (see chapter 8).
To get more columns in the window, you can enter that the channel names are shown in their short
mode (see chapter 3.d).
If you activate on the same tab sheet the option "Show channel count in lists" the number of channels
of each satellite, transponder and each FAV list is shown behind the name of this list.
Especially when you want to move channels from the beginning to the end of your list, it may be useful
to use the split function. With this function you can split your list into two parts, one showing the
beginning and the other showing the end of your settings (see chapter 3.b.)