ER-A520/ER-A530 INSTRUCTION MANUAL

Department key positioning
PGM 2
You can assign a department code to each key position. Each key position has a corresponding key number.
Departments may be freely selected for the number of department keys and their positions.
To assign the department to a key position, select the key number of the position.
For key number positions, refer to section “3 Standard key number layout” in chapter “KEYBOARD”.
2119
Procedure
To program any key number
2119 Key number
Dept. code
. @ @ t Ç
(max. 3 digits)
Cancellation
(1 - 99)
To program the next sequential key number
Note
The key number placement is determined by your local authorized SHARP dealer.
Example
Key operation2 t
Ç
Print
2119 .@
1 @ 1 t
Key no.
Color Video Monitor (CVM) control character
PGM 2 2158
This programming enables you to assign each department with a number that can be used as a CVM control
character. This number is converted to a two-digit character code that is transmitted for use with a CVM device.
Procedure
2158 Dept. code
CVM control character
. @ @ t Ç
(1 - 99)
To program any dept.
To program zero
(0 - 255)
To program for the following dept.
Example
Programming 16 as CVM control character for department 1
Key operation
2158 .@
1 @ 16 t
Ç
Print
Character code converted
109