ER-A520/ER-A530 INSTRUCTION MANUAL

2
Validation printing function (Slip printer)
Your register can perform validation printing when it is connected with the slip printer. For the details about the
slip printer, contact your authorized SHARP dealer.
1. Set a validation slip to the slip printer.
2. Press the ∏ key. The validation printing will start.
Note
When you make an entry for which compulsory validation printing can be overridden by performing
the following operation. If you need this function, Contact your authorized SHARP dealer.
3
1. Move the mode key to the MGR position.
2.
Bill printing
. ∏
This function is used for issuing bills to customers/guests. Your register can print bills on a slip printer or
receipts on the register depending on the programming. You can issue bills when GLU/PBLU/Manual PB/CB
entries are done only, for every entry or when a media key is pressed. For this selection, please consult your
authorized SHARP dealer.
When bill printing is compulsory, the register will print a bill automatically in case it is to be printed on receipts
and when a slip is inserted in case it is to be on a slip printer.
When bill printing is non-compulsory, use the following procedure to print a bill.
Bill on receipts
Bill on the slip (auto feed)
XX
No. of lines of
slip feed
Ω
Note
This function is available immediately after the finalization of transaction (including after pressing
the S or the f key).
4
Printing of the employee’s arrival and departure times (Slip printer)
Your register can print the employee’s arrival and departure time when it is connected with the slip printer.
For the details for connecting a slip printer, please contact your authorized SHARP dealer.
For printing of the arrival and departure times, you must be in the OP X/Z mode.
Printing of arrival time
1 ∏
Printing of departure time
2 ∏
74