ER-A520/ER-A530 INSTRUCTION MANUAL

More documents

Recommendations

Info

6 Removing the till and the drawer The till in the register is detachable. After closing your business for the day, remove the till from the drawer and keep the drawer open. To detach the drawer, pull it forward fully with the till removed, and remove it by lifting it up. The 6-denomination coin case is detachable. Coin case Till Drawer 7 Opening the drawer by hand The drawer automatically opens normally. However, when power failure is encountered or the machine becomes out of order, slide the lever located on the machine bottom toward the rear. (See the figure below.) The drawer will not open if it is locked with a drawer lock key. Lever 222
8 Before calling for service The malfunctions shown in the left-hand column below, labelled “Fault,” do not necessarily indicate functional faults of the machine. It is therefore advisable to refer to the “Checking” shown in the right-hand column before calling for service. Fault (1) The display won’t be illuminated even when the mode switch is turned to any other position than “OFF”. (2) The display is illuminated, but the whole machine refuses registrations. (3) No receipt is issued. (4) No journal paper is taken up. (5) Printing is unusual. Checking • Is power supplied to the electrical outlet? • Is the power cord plug out or loosely connected to the electrical outlet? • Is a cashier code assigned to the register? • Is the mode switch set properly at the “REG” position? • Is the receipt paper roll properly installed? • Is there a paper jam? • Is the receipt function in the “OFF” status? • Is the print head release lever at the printing position? • Is the take-up spool installed on the bearing properly? • Is there a paper jam? • Is the print head release lever at the printing position? • Is the paper roll properly installed? Error message table Text no. Description In default of programming 1 Registration error ENTRY ERROR 2 Misoperation error MISOPERATION 3 Desired code is not programmed yet. NO RECORD 4 (Reserved) 5 Secret code error SECRET CODE 6 Code is not free NOT FREE 7 Memory is full. MEMORY FULL 8 Insert slip paper. INSERT SLIP 9 The entered server/cashier’s code is not authorized. NO AUTHORITY 10 Stock is empty. OUT OF STOCK 11 Compulsory pushing the subtotal key SBTL COMPUL. 12 Compulsory tendering TEND COMPUL. 13 Compulsory GLU/PBLU entry PB COMPUL. 14 (Reserved) 15 Compulsory cover count entry COV CNT COMP 16 Check edit error (for manual PB entry) C/D ERROR 17-19 (Reserved) 20 Remote printer off line OFF LINE 21 (Reserved) 22 Overlapped server/cashier error SERVER ERR. 23-26 (Reserved) 27 Power off POWER OFF 28-29 (Reserved) 30 Compulsory tender entry for tip TIP ERROR 31 Compulsory non-add code # COMPULSORY 32 The server/cashier is not assigned. NOT ASSIGNED 33 (Reserved) 34 Overflow limitation OVER LIMIT. 35 The open price entry is inhibited. INH. OPEN PR 36 The unit price entry is inhibited. INH. UNIT PR The direct non-tendering 37 finalization after previous NOT NON-TEND tender entry is inhibited. 38 Read error of scale data SCALE ERROR Text no. Description In default of programming 39-47 (Reserved) 48 Enter check number ENTER CHECK# 49 Enter cover count COVER COUNT 50 (Reserved) 51 Weight on scale WEIGHT 52 Closed check file is full. C.FILE FULL 53 (Reserved) 54 Entry of tare weight ENTR TARE WT 55-60 (Reserved) 61 Desired code is not programmed yet. (learning function) NO RECORD 62 Enter price and dept. no. PRICE → DEPT 63 Enter price and dept. no. PRICE & DEPT 64 Enter dept. no. ENTER DEPT# 65-66 (Reserved) 67 REG buffer is full. BUFFER FULL 68-69 (Reserved) 70 Price entry at UPC refund ENTER PRICE 71 PLU/UPC file is full. UPC FULL 72-73 (Reserved) 74 Non-accessed UPC delete job D E L E T E 75 (Reserved) 76 Closing the drawer is compulsory. CLOSE DRAWER 77 Price level shift error ENTER P.SFT 78 (Reserved) 79 Reading of undefined vender coupon UPC OP ENTER 80 (Reserved) 81 Message for prompting entry of secret code ENTR SECRET# 82-83 (Reserved) 84 Data backup send success SEND OK 85 Data backup receive success RECEIVE OK 86 Data backup communication error COM. ERROR 87 Backup data format error DATA ERROR 88 Data backup time out error TIME OUT 89-93 (Reserved) 94 Age limitation error AGE ERROR 223
Page 1 and 2:
ELECTRONIC CASH REGISTER INSTRUCTIO
Page 3 and 4:
INTRODUCTION Thank you very much fo
Page 5 and 6:
Taxable subtotal ·········
Page 7 and 8:
Functional programming 2 (#2111) ·
Page 9 and 10:
Closed GLU/PBLU report ······
Page 11 and 12:
EXTERNAL VIEW OF THE ER-A530A Front
Page 13 and 14:
KEYBOARD 1 ER-A520A standard keyboa
Page 15 and 16:
NO DEL No delete key C NEXT Condime
Page 17 and 18:
LEVEL # PLU level shift number key
Page 19 and 20:
KEYS AND SWITCHES 1 Mode switch and
Page 21 and 22:
DISPLAYS 1 Operator display The ope
Page 23 and 24:
Procedure ■ Sign-on Variant 1 : (
Page 25 and 26:
UPC entries Scan UPC code Ä UPC co
Page 27 and 28:
Successive multiplication entries T
Page 29 and 30:
Single item cash sale (SICS)/single
Page 31 and 32:
ii) Manual scale entries of refunde
Page 33 and 34:
Example Direct PLU1: PLU code 1 (PL
Page 35 and 36:
Example PLU price level 1: PLU 1 ($
Page 37 and 38:
Mix-and-match entries This function
Page 39 and 40:
UPC learning function When you ente
Page 41 and 42:
Example • Price change mode Key o
Page 43 and 44:
3 Finalization of transaction Cash
Page 45 and 46:
4 Food stamp calculations Food stam
Page 47 and 48:
5 Tax calculations Automatic tax Wh
Page 49 and 50:
Tax status shift Your machine allow
Page 51 and 52:
Example Key operation Print 111 n C
Page 53 and 54:
Deposit entries Deposit refers to a
Page 55 and 56:
Bill totalizing/bill transfer Bill
Page 57 and 58:
Example One of the dept. 9 items is
Page 59 and 60:
7 Auxiliary entries Percent calcula
Page 61 and 62:
Refund entries If a refund item is
Page 63 and 64:
Gratuity Calculation When the payme
Page 65 and 66:
Tip editing This function is used f
Page 67 and 68:
Received on account entries Procedu
Page 69 and 70:
10 WASTE mode This mode is used to
Page 71 and 72:
3 Subtotal void You can void an ent
Page 73 and 74:
OVERRIDE ENTRIES Programmed limits
Page 75 and 76:
SPECIAL PRINTING FUNCTIONS 1 Copy r
Page 77 and 78:
5 Printing of header and footer gra
Page 79 and 80:
FOR THE MANAGER PRIOR TO PROGRAMMIN
Page 81 and 82:
79 Alphanumeric character code tabl
Page 83 and 84:
Time Set the time using the militar
Page 85 and 86:
Note Group number You can assign a
Page 87 and 88:
Functional selection PGM 2 Procedur
Page 89 and 90:
4 Programming for discount keys (-)
Page 91 and 92:
Functional programming PGM 2 Proced
Page 93 and 94:
Programming for the Ç, Å, ', and
Page 95 and 96:
9 Programming for the automatic tax
Page 97 and 98:
• If the tax is not provided for
Page 99 and 100:
2 Setting the register and consecut
Page 101 and 102:
Procedure One- or two-*digit number
Page 103 and 104:
Example Programming the tax rate 4%
Page 105 and 106:
Procedure 2110 Dept. code *ABCDEF .
Page 107 and 108:
A limit amount (HALO) of entry You
Page 109 and 110:
Group number You can assign departm
Page 111 and 112:
Department key positioning PGM 2 Yo
Page 113 and 114:
Sign (+/-) The function of every PL
Page 115 and 116:
Unit prices PGM 1 PGM 2 1210 Direct
Page 117 and 118:
* Item: Selection: Entry: A Delete
Page 119 and 120:
Example Programming ABCDEF=010001 f
Page 121 and 122:
Commission groups PGM 2 2215 2235 D
Page 123 and 124:
Age limitation PGM 2 2280 2236 2081
Page 125 and 126:
Adding the stock quantity Example T
Page 127 and 128:
Example Programming mix-and-match t
Page 129 and 130:
Assigning PLUs for condiment entry
Page 131 and 132:
Programming Non-PLU code format PGM
Page 133 and 134:
Example Programming of PLU 1 (level
Page 135 and 136:
6 Programming for miscellaneous key
Page 137 and 138:
Example Programming “Ÿ” for th
Page 139 and 140:
Percent entry type (%) PGM 2 2310 Y
Page 141 and 142:
Vendor or store coupon selection (-
Page 143 and 144:
*2: Item: Selection: Entry: A GLU/P
Page 145 and 146:
High amount lockout (HALO) for chec
Page 147 and 148:
CAT programming When you use a cred
Page 149 and 150:
Function no. Key or function In def
Page 151 and 152:
Function no. Key or function In def
Page 153 and 154:
Functional programming Procedure PG
Page 155 and 156:
Available mode for PLU level shift
Page 157 and 158:
**P: 3 * Item: Selection: Entry: A
Page 159 and 160:
**P: 11 (ABCDEFGH: Always enter 0.)
Page 161 and 162:
Programming of logo messages Your r
Page 163 and 164:
Setting the time range for hourly r
Page 165 and 166:
Functional programming for the prin
Page 167 and 168:
Validation message You can program
Page 169 and 170:
Example Assigning channel 1 to the
Page 171 and 172:
Remote printer name Procedure PGM 2
Page 173 and 174: RS-232C interface PGM 2 6110 6111 6
Page 175 and 176: Programming the CAT interface 7116
Page 177 and 178: Secret codes to control access to t
Page 179 and 180: 11 TRAINING mode The training mode
Page 181 and 182: Program for: Mode switch position J
Page 183 and 184: 3 Reading of programmed key nos. fo
Page 185 and 186: 13 Reading of programmed items for
Page 187 and 188: 14 Reading of programmed items for
Page 189 and 190: 16 Reading of programmed tax tables
Page 191 and 192: EAN-13 • Ordinary EAN-13 code (us
Page 193 and 194: Item Mode switch position X1/Z1 X2/
Page 195 and 196: Item Dynamic UPC report by associat
Page 197 and 198: 2 Daily sales totals General report
Page 199 and 200: Item 1 counter and total Item 1 tot
Page 201 and 202: Cashier/Server report Using this fu
Page 203 and 204: Full department report Individual g
Page 205 and 206: UPC code UPC total for price level
Page 207 and 208: PLU/UPC zero sales report by depart
Page 209 and 210: Closed GLU/PBLU report • Sample X
Page 211 and 212: Transaction report Cash in drawer r
Page 213 and 214: Deleting of non-accessed UPCs • S
Page 215 and 216: COMPULSORY CASH/CHECK DECLARATION I
Page 217 and 218: OPERATOR MAINTENANCE 1 In case of p
Page 219 and 220: 4 Installing and removing the paper
Page 221 and 222: Removing the journal paper roll Are
Page 223: 5 Cleaning the print head When the
Page 227 and 228: SPECIFICATIONS Model: ER-A520A/A530
show all

ER-A520/ER-A530 INSTRUCTION MANUAL

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?