ER-A520/ER-A530 INSTRUCTION MANUAL

PROGRAMMING
This chapter illustrates how to program your cash register.
Basic instructions
All the programming items can be programmed by the Job-Code-Based Programming described later.
Also your machine allows you to program some items using the Direct Programming, which does not require
you to enter the job code. However, object keys (shown below) must be allocated on the keyboard. For the keys
not allocated on the keyboard, you cannot use the direct programming.
Job-Code-Based Programming
Simplified procedure :
Direct Programming
Sample procedure :
XXX Data entry
. @ Ç
(Job code)
Data entry
–
(Object key)
Ç
Preparations for programming
1. Plug your machine into a standard grounded AC outlet.
2. Turn the mode switch to the PGM1 or PGM2 position.
To set the mode switch to the PGM1 position, use the manager or submanager key; and to set it to the
PGM2 position, use the manager key.
3. Check to see whether both journal and receipt rolls are present in the machine. If they are missing, install
journal and receipt paper rolls correctly referring to the procedure in “4. Installing and removing the paper
roll” under “OPERATOR MAINTENANCE”.
4. Program the necessary items into your machine.
1
Direct Programming
Setting the date and time
Date
PGM 1 PGM 2
Enter the month (one or two digits), day (two digits), and year (four digits : 2000 – 2099) in this sequence.
Procedure
XXXXXXXX
#/
TM
Date (seven or eight digits)
Example
Key operation
#/
08262004 = TM
Print
Date
80