You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
FREQUENTLY-USED FUNCTIONS<br />
Note: The default setting of SS is 03, which means once an object is detected<br />
more than 3 grids, the system will get triggered. So the value of SS must be<br />
less than the number of grids that you set up for the motion detection area.<br />
3) TS (Time of Sensitivity)<br />
“TS” is to set the sensitivity regarding how long one object stays in the detection<br />
area and triggers the recording. The smaller the value is, the higher sensitivity for<br />
motion detection.<br />
The highest sensitivity setting is 00, and the lowest sensitivity setting is 15. The<br />
default setting is 02.<br />
4) DET<br />
Select if you want to activate the motion detection function for the selected channel<br />
(ON/OFF).<br />
5) ALARM<br />
Select N.C./ N.O depending on your installation need. The default alarm value is<br />
OFF.<br />
6) AREA<br />
Click “EDIT” to set the motion detection area.<br />
There are 16 × 12 grids per camera for all channels. Pink blocks represent the area<br />
that is not being detected while the transparent blocks are the area under<br />
detection.<br />
5.5 PTZ Camera Setting (For Selected Models Only)<br />
Right-click to display the main menu, and select “ADVANCE CONFIG” “REMOTE”.<br />
ADVANCE CONFIG<br />
CANERA CH1 CH2 CH3 CH4 CH5 CH6 CH7 CH8 CH9 CH10 CH11 <br />
DETECTION DEVICE PTZ<br />
ALERT ID 00<br />
NETWORK PROTOCOL NORMAL<br />
SNTP RATE 2400<br />
DISPLAY<br />
RECORD<br />
REMOTE<br />
EXIT<br />
1) DEVICE<br />
For the PTZ camera, select “PTZ”.<br />
2) ID<br />
Click the current value to set the ID number (0 ~ 255) for the connected PTZ<br />
camera if necessary.<br />
23