Gears, Chains, and Sprockets - VEX Robotics

9. Press E to start the Extrude tool.10. Select the circle as the profile.11. Click Midplane.Create a SketchIn this section of the exercise, you create a sketch forthe hole through the spur gear.1. On the Standard toolbar, click 2D Sketch.2. Select the front face of the extruded circle.3. On the ViewCube, click Front.12. For Distance, enter 0.375.4. Click Two Point Rectangle.5. Create a rectangle as shown.6. Click the down arrow beside the Constrainttool. Click the Vertical constraint tool.13. Click OK.7. Select the projected midpoint of the gear (1).Select the midpoint of the lower edge (2).14. Save the file.Create Phase■31