Gears, Chains, and Sprockets - VEX Robotics

14. Click OK.3. Click again to create a work plane throughthe center of the gear.15. Click Fillet.4. Click Mirror.16. Select the inside edge of the extrusion.17. For Radius, enter 0.039.18. Click OK.Mirror the FeatureIn this section of the exercise, you mirror theextrusion and the fillet.1. Click Work Plane.2. Move the cursor over the top edge of a geartooth. Click when the center point of theedge is displayed as shown.5. In the browser, select the extrusion and filletyou created in the previous steps. You canalso select the features in the graphicswindow.6. In the Mirror dialog box, click Mirror Plane.Select the work plane.7. Click OK. Rotate the gear to view the mirroredfeatures.8. On the ViewCube, click Home.9. Turn off the visibility of the work plane.Extrude the Sketch for the Small CircleIn this section of the exercise, you extrude the sketchfor the small circle.1. Click 2D Sketch. Select the inside front face ofthe gear.2. On the ViewCube, click Front.3. Click Center Point Circle.Create Phase■35