Gears, Chains, and Sprockets - VEX Robotics

More documents

Recommendations

Info

Engineering1. If you were designing the winch system for a Coast Guard search and rescue helicopter, howwould you adjust the mechanism’s speed and torque with gear ratios to maximize the efficiencyand utility of the system?2. How would you test the system to reach your goal of maximum efficiency?MathSuppose a rescue helicopter is lifting a swimmer out of the water. The total load at the end of the cableis 210 lbs. The winch works by turning an axle, about which the cable becomes spooled.1. What is the torque when the spool has a radius of 3 inches?2. As more cable is drawn in and the spool grows, the radius becomes 5 inches. What is thenew torque?60■Unit 6: Gears, Chains, and Sprockets
Page 3 and 4:
SuppliesSoftwareAn assembled the ge
Page 5 and 6:
PhaseBuildStandardScience (NSES)Uni
Page 7 and 8:
Think PhaseOverviewThis phase expla
Page 9 and 10: Spur GearsSpur gears have been used
Page 11 and 12: The driving torque applies some for
Page 13 and 14: Idler GearsGears can be inserted be
Page 15 and 16: Compound Gear RatioCompound gears a
Page 17 and 18: Chain DrivesSprockets and chains ar
Page 19 and 20: Create PhaseOverviewThis phase desc
Page 21 and 22: Icon Name DescriptionRectangularPat
Page 23 and 24: Example: Generated GearsIn the foll
Page 25 and 26: Enter data to design the gear set.I
Page 27 and 28: Exercise: Generate Spur GearsIn thi
Page 29 and 30: 12. To check your design again, cli
Page 31 and 32: 9. Press E to start the Extrude too
Page 33 and 34: 4. For Operation, select Cut.2. Exp
Page 35 and 36: 14. Click OK.3. Click again to crea
Page 37 and 38: Extrude the Sketch on the Back Face
Page 39 and 40: 7. For Count, enter 5.8. For Spacin
Page 41 and 42: Insert an iFeatureIn this section o
Page 43 and 44: Exercise: Animate a Gear AssemblyIn
Page 45 and 46: 9. Scroll back to SHAFT-3000:5. Rig
Page 47 and 48: Required Supplies and SoftwareThe f
Page 49 and 50: 2. To complete the next step:■■
Page 51 and 52: 4. To complete the next step:■■
Page 53 and 54: Amaze PhaseOverviewIn this phase, y
Page 55 and 56: f. Set up the test stand between tw
Page 57 and 58: Figure 4: 36:60 ReductionFigure 5:
Page 59: STEM ConnectionsBackgroundThe Unite
show all

Gears, Chains, and Sprockets - VEX Robotics

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?