Gears, Chains, and Sprockets - VEX Robotics

4. To complete the next step:■■■■■■■Slide the 84 Tooth Gear [G84] and a Thick Spacer [SP2] onto the 4" shaft from the test stand.Slide two Collars [COL], a 12 Tooth Gear [G12], a Thin Spacer [SP1], and 2 Delrin Washers[WP] on a 3" shaft [SQ3].Insert the 3" Shaft into the Bearing Flat.Bolt the assembly from the previous step to the 2" Standoffs on the test stand.Insert the 3" Shaft fully into the Motor and tighten the two Shaft Collars.Slide the 84 Tooth Gear and Thick Spacer up against the Bearing Flat you attached tothe 1x2x1x15 C-Channel and tighten the Shaft Collars.Ensure that the 84 Tooth Gear and 12 Tooth Gear are aligned such that the teeth mesh.The completed model is as shown:Build Phase■51