BSL PRO Software Guide - Biopac

150 Part CShow Input ValuesWhen Show Input Values is selected from the MP UNIT menu, a new window appears on the screen and displaysthe values of all channels that were setup to Enable Value Display (see Note below). The Input Values windowcan be resized and moved to any position on the screen. If the MP UNIT is disconnected or without power, the InputValues dialog will read “OFF.”Values are displayed in real time for the appropriate analog channels whether an acquisition is in progress or not,which allows you to display values prior to or after an acquisition; calculation channels will only be displayedduring acquisition.The table on the following pages explains the Input Values (IV) window options.Note: The IV window is disabled during High Speed acquisition (see page 784).The IV window does not update calculation channels when the recording is stopped or whilewaiting for a trigger device to reach the triggering level.The Enable Value Display option must be checked for Input Values display to work. TIP The FFT transformation cannot be performed in real time (i.e., during anacquisition), but you can emulate online spectral analysis using severalonline filters and the Input Values window.See also…Save as Graph Template, page 7185.Show Input Values Display optionsIncoming data can be displayed either as numeric values or in a “bar chart” format. These options are represented byicons that can be selected from the mode menu at the top of the Input values display.Clicking the Options button of the Input values display generates an Input Values Setup dialog where you can setadditional display parameters:Visit the online support center at www.biopac.com