BSL PRO Software Guide - Biopac

241Tile WaveformsChoosing Tile waveforms centers the waveform in the display window by adjusting the vertical offsetof the selected waveform. In Chart mode, if there are multiple waveforms displayed, the waveformswill be centered in their tracks. In Scope mode, display is optimized to show all the visible waveformdata with no overlap. Tile waveforms is not available in X/Y mode.Before Tile Waveforms After Tile WaveformsChartModeScopeModeTILE WAVEFORMS In Chart Mode In Scope ModeApplies to Selected channel All active (visible) channelsEffect on Horizontal(Time) ScaleEffect on Vertical(Amplitude) ScaleChannel order(top to bottom)NoneWhen multiple waveforms aredisplayed, each waveform is centeredin its “track.” If tracks were resized,this function will reset (equalize) thetracks and then center eachwaveform in its track.Numerical order (Top=low,Bottom=high) unless channel orderwas manually changed viaDisplay>Set Wave Position.NoneLimitations None NoneWhen to useWhen the vertical offset has shiftedthe channel in its track.Display is optimized to show all thevisible waveform data with no overlap.Waveforms are spaced evenly along thevertical axis of the screen. Eachchannel’s data is completely visible andis separated from the other channels.Numerical order (Top=low,Bottom=high) unless channel order wasmanually changed via Display>SetWave Position.When multiple waveforms areoverlapped and hard to distinguish,especially if displayed in the same color.This pulls the waveforms apart, in orderto view each channel.Autoscale WaveformsWhen Autoscale waveforms is selected, BSL PRO determines the best fit for each displayedwaveform. The software adjusts the vertical offset so that each channel is centered in the window (or