New! - Norman Equipment Co.

SERIES AZ 200 DIAGNOSTICSFunction table of visual diagnostic LED, electronic diagnostic output and safety outputsLED State AZ 200SafetyOutputsDiagnostic OutputsAZ200...-3P2PAZ200...-1P2POUT OUT2 OUT3 OUTGreenDoor open0 V 0 V 0 V 0 V 0 VGreenDoor closed0 V0 V 0 V 0 V 20 VYellow & GreenDoor closed and actuator inserted24 V24 V 0 V 0 V 224 VBlinking red (1–6 impulses)Error: see blinking codes24 V 124 V 24 V 0 V 20 V1After 30 min ➞ 0 V2With door detection sensor (-T) always highDiagnostic LED error codesThe blinking sequence of the redLED of the AZ 200 identifies theactive error. The following errorsare indicated:Indication (red)Meaning1 blinking impulse Error output Y12 blinking impulses Error output Y23 blinking impulses Cross-wire4 blinking impulses Temperature too high5 blinking impulses Target error6 blinking impulses Error target combinationContinuous redErrorBlinking Codes (red) Meaning Autonomous switch-off after Cause1 blinking impulse Error output Y1 30 min. Error in output test or voltage at output “Y1”, althoughthe output is switched off2 blinking impulses Error output Y2 30 min. Error in output test or voltage at output “Y2”, althoughthe output is switched off3 blinking impulses Cross-wire 30 min. Cross-wire between the output cables or error atboth outputs4 blinking impulses Temperature too high 30 min. Temperature measurement indicates too high aninner temperature5 blinking impulses Target error 0 min.The difference between the code (frequency) ofthe detected target and the set value is too large,false target6 blinking impulses Error target combination 0 min. An invalid combination of targets was detected atthe 4 coils of the AZ200 T. (Current setting: latchingbolt detected & door target not detected => latchbreakage or tampering attempt)6Continuous Red Internal error 0 min.181