SDISC Assembler Call - NetEx

Utility/Test ProgramsNTXCONSThis program allows a user or operator to monitor messages and status of the local DX NETEX adapter, andany other host connected to NETEX with a remote operator interface enabled. It may be run demand orbatch.To execute this command demand, enter:@XQT[,options] N2X.NTXCONSNTXCONS has the following @ XQT options:K Use the KEYIN$ interface, not the AREAD$/APRINT$ interface.N Do not send output messages to PRINT$ file in addition to the requestorR Retain routing to last requestor. If this is set, unsolicited messages from the connected DX NETEXadapter will be sent to the last user who did a command via KEYIN$.NTXCONS will accept the following commands:CONNECT [host]DISCONNHDLS[n]HDLXHELPIFDISPLAYIFDR ssnmStart NTXCONS NETEX session. If host is omitted, the first locally attachedNETEX is used.Terminate NTXCONS NETEX sessionInitiate loopback server, on interface number n (if n is specified). This command willdisplay the hexadecimal DREF to be used as the target of a Host Driver Loopback(HDL) message from any NETEXThis command terminates loopback server.This command prints the HELP menu.This command displays the interface status.This command drains the interface (ssnm is the four-character name on the SYScard.)IFHA ssnm This command halts the interface (ssnm if the four-character name on the SYS card.)IFST ssnmThis command starts the interface (ssnm is the four-character name on the SYS card.)KILLThis command aborts NTXCONS.@EOFThis command exits NTXCONS.TRACEON/OFF This command sets and clears tracing for H307IP.Once connected, any NETEX command can be issued. If KEYIN$ is being used, the caller must have FULLor DISPLAY console privileges; if not, no validation of the caller is done.Note: The NTXCONS service is not currently available on the NESiGate platform.Page 86 Utility/Test Programs MAN-REF-H307IP-04