SDISC Assembler Call - NetEx

H307IP User Interface Error CodesThe following codes are H307IP user interface error codes. Refer to the NETEX Programmer’s ReferenceManual for additional NRBSTAT error codes.0000 Successful completion0001 Pdata was truncated. A read-type operation completed normally, but the buffer provided by theuser was not large enough to hold the data. NRBLEN and NRBUBIT reflect the amount of datareceived; however, the amount of data moved to the user’s buffer was only the amount specifiedin NRBBUFL. The status of the connection is not affected.0002 Invalid Pdata Buffer Address. NRBBUFL and NRBBUFA do not specify a block of storage thatfits entirely within the user’s addressable memory. The operation is suppressed. The status of theconnection is not affected0004 Invalid Request. The request code (NRBREQ) is not valid. The operation is ignored and thestatus of the connection is not affected.0005 Invalid Pdata Buffer Length. The buffer size specified (NRBBUFL for reads and NRBLEN forwrites) exceeds an implementation defined NETEX maximum. The operation is suppressed. Thestatus of the connection is not affected.0006 Invalid Odata Buffer Length. The buffer size specified in NRBPROTL exceeds an implementationdefined NETEX maximum. The operation is suppressed. The status of the connection is notaffected.0011 Odata was truncated. A read-type operation completed normally, but the Odata buffer providedby the user was not large enough to hold the data. NRBPROTL reflects the amount of data givento the user. The status of the connection is not affected.0012 Invalid Odata buffer address. NRBPROTL and NRBPROTA do not specify a block of storagethat fits entirely within the user’s addressable memory. The operation is suppressed. The statusof the connection is not affected.0010* No NREF specified. The user interface detected that the NREF is not valid. The probable causeis the lack of, or a failing, CONNECT or OFFER.0310 NRB for request is already in use. The user has attempted to re-use an NRB before a previousrequest with that NRB has completed. The request is rejected,0503* The number of users accessing H307IP has exceeded the MAXUSERS parameter. The session isrejected0903 NRBDMODE on a write-type request is not supported by the hardware and/or H307IP.0904* Maximum outstanding writes exceeded. The number of write requests outstanding against a singleconnection exceeds the maximum allowable of 1. The request is rejected. The status of theconnection is not affected.0905* Maximum outstanding reads exceeded. The number of read requests outstanding against a singleconnection exceeds the maximum allowable of 1. The request is rejected. The status of the connectionis not affected0907* Pending read request terminated because of an internally generated disconnect (e.g., SDISC) orexit by user.0908 Invalid SCB address in NRB. User probably over-wrote OS area of the NRB.Page 110 Appendix A. NRBSTAT Error Codes MAN-REF-H307IP-04