SDISC Assembler Call - NetEx

0911* Error on TRMRG$ request.0921 Output data transfer was truncated by the channel, generally because of a “stop-bit” in the datablock. Correct the data and re-start the transfer.0922 Code Conversion has not been done. A read request has completed but the data has not beencode converted because the DATAMODE specified an unsupported code conversion. The statusof the connection is not affected.0923 Interface is use was HALTed by operator.0930* N2X$COMN bank not configured for this system’s SITEID. Reload correct bank or rebuildH307IP with correct configuration statements.0932 Adapter memory unavailable. Buffer memory was not available in the DX/E unit to accept thisrequest and data. The status of the connection is not affected.0933* I/O error. Status 013 from exec. Adapter or path has been DOWNed by the operator.0934* I/O Error. An I/O error on the adapter host interface occurred during the processing of the request.The results of the request, and the status of the connection are unknown. It is recommendedthat the session be terminated.0935* I/O Error. Status 07, 11 from the exec. No sense bytes were returned on a Unit Check error.Verify that the adapter host interface is profiled for 32 sense bytes. If the adapter interface is configuredas HYPDEV rather than ARBDEV, refer to the Memo to Users for more information.0951* Allocation failed - setup channel program error. The connect or offer request has failed becausethe used interface detected that an I/O error occurred while executing the channel program tosetup the subchannels allocated for the path to the DX unit.0952* Allocation failed - Sense id is not correct. The connect or offer request has failed because theuser interface detected that the subchannels allocated for the path to the adapter did not respondcorrectly to a Sense ID operation. This indicates they are not subchannels to the adapter.0953* Allocation failed - abort failed. The connect or offer request has failed because the user interfacedetected an error aborting any sessions previously associated with the subchannels allocated forthe path to the adapter.0954* Allocation failed - invalid interface name. The connect or offer request has failed because theuser interface detected that NRBSSNM does not specify a valid interface name.0955* Allocation failed - unable to allocate units. The connect or offer request has failed because theuser interface was unable to allocate a pair of subchannels for the path to the NETEX adapter.The probable cause is that all the subchannels are offline or are all allocated to other sessions.0956* Attempt to ASG adapter device gave facility reject bit 1*/35. The probable cause is a wrong I/Oconfiguration for this system.0958* Allocation failed - the Sense Configuration data had no data for NETEX Co-processor or NESi-Gate Channel Offload software.1101 DWRITE invalid datamode. The datamode specified for this DWRITE request is invalid. Therequest is rejected. The status of the connection is not affected.1103 DWRITE invalid Odata length. The Odata length (NRBPROTL) specified for this DWRITE requestis invalid. The length of the message proper (NRBPROTL) MUST BE BETWEEN 8 AND64 BYTES INCLUSIVE. The request is rejected. The status of the connection is not affected.MAN-REF-H307IP-04 Appendix A. NRBSTAT Error Codes Page 111