SDISC Assembler Call - NetEx

Seconds to allow incoming data to remain in the adapter unread before disconnecting the session (SeeNRBDATO).MAXBLOCK (65535)Maximum words of Pdata to be sent or received in one request.MAXUSERS (16)Maximum simultaneous user programs with active sessions.All other parameters should be left as set.Step 2c. Insert User Exits (Optional)If no User Exits are required, you may skip to the next step. Otherwise, see “User Exits”.Step 2d. Rebuild H307IPTo make a site-specific version of H307IP, a build must be done.Examine the element BLD in the release file and modify as necessary for local filename conventions, and editas required.1. Enter the following command:@ADD N2X.BLDThis command will produce updated relocatables (in N2X) and absolute common bank (in TPF$). Youwill be asked to specify element(s) to assemble. The normal response is one of the following: ALL or@EOF2. Copy the new common bank(s) to your registered NCCB file. There will be one for each SYS specified,called N2X$$$siteidm, plus an N2X$COMN which is a copy of the first SYS's common bank. The entireCB file should be copied to each SYS system.For Example:@USE CB,SYS$*yournccbfile@COPY,A TPF$.,CB.3. Then the common bank must be reloaded and initialized on each system. If there was only one SYS configured,enter the following command:Note:@XQT N2X.RELOADIf there are multiple sites configured, each will have a common bank in CB called N2X$$$siteid. Thecommon bank for this system must be renamed:@CHG,AThen enter the following command:@XQT N2X.RELOADCB.N2X$$$siteid,.N2X$COMN“Step 3. Define Network Configuration and Run the Configuration Manager” and “Step 4. Load thePAM Using the NCT Loader” are only required when the offload NETEX is initially configured, andthen only after network configuration changes.Page 80 Installation MAN-REF-H307IP-04