SDISC Assembler Call - NetEx
SDISC Assembler Call - NetEx
SDISC Assembler Call - NetEx
- No tags were found...
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
RATEThis required parameter specifies the protocol level of NETEX that will be used between the twohosts specified in this route. All release 1.x NETEX products use only type 1 protocol. All release2.x NETEX products use either type 1 or type 2 protocol. All release 3.x NETEX products use onlytype 2 protocol. The following protocol-type codes are used with the PROT operand.1 = use type 1 protocol only2 = use type 2 protocol only (default)Check the release levels of the NETEX products used in your configuration. If any release 1.xNETEX is used, use PROT=1 for all routes to or from the release 1.x NETEX host. If any release 3.xNETEX is used, use PROT=2. If both type 1 and type 2 protocols are used, both PROT=1 andPROT=2 are explicitly used in the same HOST statement.This optional parameter specifies the limit on transmission rates to this host. The rate is expressed asa decimal number followed by K (kilobits per seconds).OPTIONSThis optional parameter specifies options that apply to the host. The only defined option is NOAPR,indicating that the host does not support Alternate Path Retry.MAN-REF-H307IP-04 Configuration Manager Page 97