SDISC Assembler Call - NetEx

CONF022E Unexpected End of File EncounteredExplanation: The end of the configuration file was encountered before the completion of the parse.System Action: Exit from module.CONF023E TRUNK not meaningful in HYPERbus environment: ‘trunk name’Explanation: The TRUNK statement is not to be used in describing a HYPERbus network.System Action: Ignore statement, free up memory allocated to adapter or link and get next card.CONF025E Invalid hexadecimal character: ‘char’ in string: ‘string’Explanation: An invalid hexadecimal character was encountered.System Action: Ignore statement, free up memory allocated to adapter or link and get next card.CONF026E Invalid INTEGER: ‘number’Explanation: An invalid integer was encountered in parse.System Action: Ignore statement, free up memory allocated to PORT and get next card,CONF027E Invalid PROTOCOL level: ‘number’ on HOST: ‘HOSTname’Explanation: A protocol level was encountered that is not currently available.System Action: Ignore statement, free up memory allocated to HOST and get next card.CONF02SE ‘parameter name’ parameter previously defined as ‘name’Explanation: A parameter was previously encountered and defined to be ‘name’.System Action: Ignore statement, free up memory allocated and get next card.CONF029I Variable truncated: ‘variable’Explanation: A variable was encountered that is longer than the specified length for that variable.System Action: Truncate to specified length and continue. This is only a warning.CONF030E ‘name1’ statement: ‘label’ encountered before ‘name2’ statement: ‘label’Explanation: The statement specified by ‘namel’ was encountered before the statement specified by‘name2’. The statement label is specified by ‘label’.System Action: Ignore statement, free up memory allocated to HOST and get next card.CONF03IE Label: ‘label’ and ADAPT: ‘adapt’ may not both be specifiedExplanation: Both a label and an ADAPT parameter may not be specified for the adapter/link.System Action: Ignore statement, free up memory allocated and get next card.CONF033E token too long: ‘string’Explanation: A token was encountered that was longer than the maximum token length.System Action: Ignore statement, free up memory allocated and get next card.CONF034E Invalid Return CodeExplanation: An invalid return code was returned from the translator phase of SCANNER.System Action: Ignore statement, free up memory allocated and get next card.CONF070E Invalid SMGnref: ‘hexvalue’, should always = FFFFExplanation: An NREF was encountered with the value ‘hexvalue’. SMGNREFs should always be‘FFFF’.System Action: Ignore statement, free up memory allocated and get next card.CONF071E SMGDREF: ‘hexvalue’ must have rightmost 2 bits = PORT: ‘value’Explanation: A DREF was encountered with the value ‘hexvalue’. The low-order 2 bits must equalthe port number ‘value’.System Action: Ignore statement, free up memory allocated and get next card.CONF073E Invalid 710-mode address: ‘address’Explanation: The 710-mode address is not in the range ‘00’ - ‘EF’.System Action: Ignore statement, free up memory allocated and get next card.MAN-REF-H307IP-04 Appendix B. ConfMang Messages Page 115