Complete (13 MB) - Chris Alston's Chassisworks

Measure from the lip on the rocker panel tothe side of the frame clip at the front of therocker panel and the rear of the frame.Bump the frame around until the frame isparallel with the rocker panel on each sideand the same distance from the frame tothe rocker lip on each side. If the lip underthe rocker panel is not straight, use a bodyhammer and dolly to straighten it beforemeasuring. Try to bump the frame aroundso that the largest measured differencebetween any two of the four rocker panellips is less than 1/4 inch.After you have finished the previous step,verify the distance from the rear framegauge hole to the back of the frame. Thelength should be within 1/8 of an inch fromside to side.#917701 Page 80