Complete (13 MB) - Chris Alston's Chassisworks

After all dimensions verify, tighten frame tothe body mounts with the alignment pinsinstalled. Verify your measurements aftertightening.In some cases, you may have to shim thesubframe to get the front-end radiator coresupport to attach. You can put shimsbetween the floor and the urethane to raisethe frame in the front. Or, you can putshims between the frame and the urethanecore support mounts. You can also shimthe firewall body mounts to lower the frameat the core support. Some vehicles comefrom the factory with shims. If your vehiclehas shims, it is probably best to reusethem.If your core support will not line up afteryou have the clip aligned and attached tothe body, then you need to reinstall thefront sheet metal. Remember, these carsare over 30 years old so there is no tellingwhat your car has been through.Sometimes you can get the core support tofit by simply loosening all its bolts andpushing it around and then retightening it.Retorque all body mounts after 1000miles of use.Reinstalling FactoryComponents to FrameReinstall the parking brake cable into theChassisworks frame using the stock springclip.#917701 Page 81