OMRG25204 oem uncert & tier 1.pdf - John Deere Industrial Engines

Service as RequiredReplacing Single Stage Air CleanerIMPORTANT: ALWAYS REPLACE air cleaner when airrestriction indicator shows a vacuum of625 mm (25 in.) H 2 O, is torn, or visiblydirty.NOTE: This procedure applies to John Deere single stageair cleaner kits. Refer to manufacturers’instructions for servicing air cleaners not suppliedby John Deere.1. If equipped, loosen body clamp.Single Stage Air FilterRG11319A –UN–06SEP002. Loosen clamp around outlet neck (A).3. Remove air cleaner.4. Install new filter so that overlap (B) of air cleaner outletneck and engine intake pipe is to specification below.SpecificationAir Cleaner Neck to EngineIntake—Overlap..................................................................38 mm (1.5 in)5. Tighten neck clamp (A) to specification below.SpecificationAir Cleaner Neck Clamp—Torque.................................6.8 N•m (60 lb-in.)IMPORTANT: Do NOT overtighten body clamp.Overtightening may cause crushing ofair cleaner body. Tighten body clamponly until snug.Installation of Single Stage Air CleanerA—Outlet Neck ClampB—Filter to Engine OverlapRG11320 –UN–07SEP006. If equipped, tighten body clamp until snug.IMPORTANT: Whenever the air cleaner has beenserviced or removed, ALWAYS fullydepress the air restriction indicatorreset button (if equipped) to assureaccurate readings.7. If equipped, fully depress air restriction indicator resetbutton and release to reset indicator.RG,RG34710,5594–19–07JAN02–1/145-3 110306PN=108