OMRG25204 oem uncert & tier 1.pdf - John Deere Industrial Engines

Storage15. Store the engine in a dry protected place. Ifengine must be stored outside, cover it with awaterproof canvas or other suitable protectivematerial and use a strong waterproof tape.OURGP11,000006C–19–27JUL06–2/2Removing Engine from Long Term StorageRefer to the appropriate section for detailed serviceslisted below or have your authorized servicing dealeror engine distributor perform services that you may notbe familiar with.1. Remove all protective coverings from engine.Unseal all openings in engine and remove coveringfrom electrical systems.2. Remove the batteries from storage. Install batteries(fully charged) and connect the terminals.3. Install fan/alternator poly-vee belt if removed.4. Fill fuel tank.5. Perform all appropriate prestarting checks. ( SeeDAILY PRESTARTING CHECKS in Lubrication andMaintenance/Daily Section.)IMPORTANT: DO NOT operate starter more than30 seconds at a time. Wait at least 2minutes for starter to cool beforetrying again.6. Crank engine for 20 seconds with starter (do notallow the engine to start). Wait 2 minutes and crankengine an additional 20 seconds to assure bearingsurfaces are adequately lubricated.7. Start engine and run at low idle and no load forseveral minutes. Warm up carefully and check allgauges before placing engine under load.8. On the first day of operation after storage, checkoverall engine for leaks and check all gauges forcorrect operation.RG,RG34710,5613–19–11OCT06–1/155-3 110306PN=135