OMRG25204 oem uncert & tier 1.pdf - John Deere Industrial Engines

Engine Operating GuidelinesNOTE: Electronically controlled governor applications maybe equipped with a rotary speed potentiometer onthe throttle (A) on the instrument panel.4. On mechanical governor (7-10% regulation) engines,pull hand throttle (A) 1/3 of the way out. Turn the handlein either direction to lock it in place.5. If equipped, depress and hold reset button (B) whilestarting.IMPORTANT: Do not operate the starter for more than30 seconds at a time. To do so mayoverheat the starter. If the engine doesnot start the first time, wait at least 2minutes before trying again. If enginedoes not start after four attempts, seeTroubleshooting Section.North American Standard Instrument Panel (1999— ) ShownRG11299X –UN–18OCT016. Turn the key switch (C) clockwise to crank the engine.When the engine starts, release the key so that it returnsto the "ON" position.IMPORTANT: If the key switch is released before theengine starts, wait until the starter andthe engine stop turning before tryingagain. This will prevent possibledamage to the starter and/or flywheel.7. After the engine starts, continue to hold the reset buttonin until the oil pressure gauge (D) reads at least 105 kPa(1.05 bar) (15 psi). The safety controls will not allow theengine to run at a lower oil pressure unless the resetbutton is held in.VDO Standard Instrument Panel (Except North America)A—Hand ThrottleB—Reset ButtonC—Key Start SwitchD—Oil Pressure GaugeRG11610 –UN–17OCT01IMPORTANT: Should the engine die when operatingunder load, immediately disengage PTOclutch and restart the engine.Overheating of turbocharger parts mayoccur when oil flow is stopped.8. Check all gauges for normal engine operation. Ifoperation is not normal, stop the engine and determinethe cause.RG,RG34710,5557–19–07JAN02–2/215-11 110306PN=55