OMRG25204 oem uncert & tier 1.pdf - John Deere Industrial Engines

Lubrication and MaintenanceLubrication and Maintenance Service IntervalChart—Standard Industrial EnginesNOTE: The service intervals below are for standardindustrial engines. See details in Sections whichfollow these charts.Lubrication and Maintenance Service Intervals250 Hour/ 500 Hour/ 2000 Hour/Item Daily 6 Month 12 Month 24 Month As RequiredCheck Engine Oil and Coolant Level•Check Fuel Filter(s)/Water Separator BowlCheck Air Cleaner Dust Unloader Valve & Indicator aPerform Visual Walkaround InspectionService Fire ExtinguisherChange Engine Oil And Replace Oil Filter bCheck Engine MountsService BatteryCheck Manual Belt Tensioner and Belt WearClean Crankcase Vent TubeCheck Air Intake Hoses, Connections, & SystemReplace Single or Dual Fuel Filter ElementsCheck Automatic Belt Tensioner and Belt WearCheck Engine SpeedsCheck Engine Electrical Ground ConnectionCheck Cooling SystemCoolant Solution Analysis-Add SCAs as requiredPressure Test Cooling SystemCheck Crankshaft Vibration Damper (6.8 L Engines) cFlush Cooling System dTest ThermostatsCheck and Adjust Engine Valve ClearanceAdd CoolantReplace Air Cleaner ElementsReplace Poly-Vee BeltCheck FusesaReplace primary air cleaner element when restriction indicator shows a vacuum of 625 mm (25 in.) H2O.•••bChange the oil for the first time after 100 hours maximum of break-in operation. For subsequent oil and filter intervals, see recommendationsin section 10.cReplace crankshaft damper every 4500 hours or 60 months, whichever occurs first.dIf John Deere COOL-GARD is used, the flushing interval may be extended to 3000 hours or 36 months. If John Deere COOL-GARD is usedand the coolant is tested annually AND additives are replenished as needed by adding a supplemental coolant additive, the flushing intervalmay be extended to 5000 hours or 60 months, whichever occurs first.••••••••••••••••••••••Continued on next pageOURGP11,0000006–19–13OCT06–1/220-2 110306PN=64