OMRG25204 oem uncert & tier 1.pdf - John Deere Industrial Engines

Lubrication & Maintenance/250 Hour/6 Month9. Fill engine crankcase with correct John Deere engineoil through rocker arm cover opening (B) or either sideoil filler (C) depending on engine application. (SeeDIESEL ENGINE OIL in Fuels, Lubricants, and CoolantSection for determining correct engine oil.)To determine the correct oil fill quantity for your engine,see ENGINE CRANKCASE OIL FILL QUANTITIES inthe Specifications Section of this manual.IMPORTANT: Immediately after completing any oilchange, crank engine for 30 secondswithout permitting engine to start. Thiswill help insure adequate lubrication toengine components before enginestarts.Rocker Arm Cover Oil FillerRG8025A –UN–19JUN00NOTE: Crankcase oil capacity may vary slightly.ALWAYS fill crankcase to full mark or withincrosshatch on dipstick, whichever is present. DONOT overfill.10. Start engine and run to check for possible leaks.11. Stop engine and check oil level after 10 minutes. Oillevel reading should be within crosshatch of dipstick.Side Oil FillerRG8054B –UN–19JUN00B—Rocker Arm Cover Oil FillerC—Side Oil FillerOURGP12,0000078–19–31OCT06–3/3Checking Engine MountsEngine mounting is the responsibility of the vehicle orgenerator manufacturer. Follow manufacturer’s guidelinesfor mounting specifications.IMPORTANT: Use only Grade SAE 8 or higher gradeof hardware for engine mounting.1. Check the engine mounting bracket, vibration isolators,and mounting bolts on support frame and engine blockfor tightness. Tighten as necessary.2. Inspect overall condition of vibration isolators, ifequipped. Replace isolators if rubber has deterioratedor mounts have collapsed, as necessary.DPSG,RG34710,111–19–07JAN02–1/130-4 110306PN=75