Protégé® Eclipse LED Keypad Installation Manual

To Change the Current AddressStep 1To change the current address enter following key press sequence:, 1, [ADDRESS 1], [ADDRESS 2], [ADDRESS 3],The device will beep four times to indicate that it has changed the address.!All three digits must be entered when programming an address. This means thatfor addresses below 100, you must enter [0] then the 2 digits of the address.For addresses below 10, you must enter [0], [0] followed by the address digit.9.3 Device Options (Menu 2)The Device Options set options that relate to the mode of operation of the Protégé® Eclipse LEDKeypad.Step 1To enter the Device Options menu enter the following key press sequence:, 2The currently assigned Device Options will be displayed using the Number LEDs.Step 2To toggle options press the keys 1 to 8 and the corresponding key LED will be lit when that optionis ENABLED.The available options are:Option 1 - Keypad beep• Enabled, the Keypad will not make a sound when a key is pressed.• Disabled, the Keypad will beep when keys are pressed.Option 2 - Zone Duplex• Enabled, Zone inputs 1 & 2 can be wired in Duplex mode to create Zones 1,2,3 & 4. PhysicalZone inputs 3 & 4 have no effect.• Disabled, All physical Zones are treated as individual Zones.Option 3 - Beep on Communication Failure• Enabled, the Keypad will emit a periodic beep if communication with the Protégé® IntegratedSystem Controller fails.• Disabled, the Keypad will not emit a periodic beep if communication with the Protégé®Integrated System Controller fails.17