Part 2

4-62 Plug-In Assembly ConfigurationWhen handshaking is enabled, the handshake sequence for either High Gate, HighFlag or Low Gate, Low Flag operation is as shown in Figure 127. When a 16-bitwide word is entered into the assembly and settling time has occured, the assemblysends a Gate output to the receiver to signal Data Valid condition. Then, after theword is transferred to the receiver, the receiver returns a Flag message to show thatdata transfer is complete and the receiver is ready for more data.SpecificationsSpecifications for the ActuatorIDigital Output assembly follow. Specifications are performancestandards, or limits, against which the assembly may be tested.Input CharactaristicsOPTION 110ACTUATORlOlGlTAL OUTPUT ASSEMBLYContact Ratings: Voltage: i 100 V peakCurrent: 1 amperelchannelPower: 100 volt ampereslchannelCAUTION: For use only in circuits fused at 1 ampere or lessand less than 100 VA.Thermal Offset: < 20 pVContaa Resistance: < 400 milliohms.Isolation: > lo6 R common to openIsolation Voltage: 170V peak any terminal to chassisGeneral InformationSingle Channel Closure Rate: > 27lsecond (Using 9835A)Switch Life: > loT0 with Contact protecttonOperating Considerations: Should not be used in a position greaterthan 30" above horizontalHandshake Lines: Optically isolated. TTL compatible, open collectoroutputContact Capacitance: < 15 pFInterchannel Capacitance: < 30 pFFraquancy ResponseCross Talk(10 kHz Reference) 1 c100 kHz 1