Part 2

Plug-In Assembly Configuration 505How to Install the Current D/A Converter AssemblyFigure 149 shows how to install the assembly in the 3497A and 3498A. After takingthe steps shown in the WARNING and CAUTION notes above, plug the assemblyinto an unused slot in the 3497A or 3498A and turn the locking key clockwise tolock the assembly in place.CONFIGURING THE ASSEMBLYTo configure the IDAC for operation, simply connect the SOURCE and SINK connec-tors on the assembly to your load. The IDAC has connectors for two opticallyisolated channels, so you can provide inputs to two separate loads simultaneously.This section shows how to connect the assembly to a typical resistive load. Sincethe channels are optically isolated, you can control devices which are floated up to170 volts above ground. To begin, let's discuss some load considerations.Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com