Part 2

I TERMINAL CARDS USED WITH THE BREADBOARD CARD IPlug-In Assembly Configuration 52920 CHANNEL UNCOMPENSATED TERMINAL CARDUsed with the 20 Channel Relay Multiplexer (Option 010). Provides straight throughconnections from the input terminals on the terminal card to the edge connectoryou have prepared on the breadboard card. Capability to add serieslshunt componentsis provided. -hp- part number is 03497-69542. See Figure 167 forschematic.16 CHANNEL DIGITAL INPUT TERMINAL CARDUsed with the Digital Inputllnterrupt Assembly (Option 050). Provides two-wireconnections for each of 16 input channels plus FLAG, GATE and GND. The logiclevels are determined by placing jumpers in designated positions to allow portionsof resistive networks to attenuate the signal. -hp- part number is 03497-69543.See Figure 168 for schematic.16 CHANNEL DIGITAL OUTPUT TERMINAL CARDUsed with the Digital Output Assembly (Option 110). Each output channel hasthree terminals labeled NO (normally open), NC (normally closed) and C (common).Terminals are also provided for GATE+, GATE-, FLAG + and FLAG-. 16-pin DIPIC sockets (JI,J3,J4 and J6) provide a means of limiting current to the N0,NCcontacts to +5V. DIP sockets J2 and J5 can be used to jumper relay commonterminal to GND. -hp- part number is 03497-69544. See Figure 169 for schematic.8 CHANNEL HIGH VOLTAGE TERMINAL CARDUsed with the High Voltage Actuator Assembly (Option 11 5). This card has provisionsfor 8 high voltage channels. The terminal strip connections are rated at252V RMS (AC) at 2 amps or 48V DC at 2 amps. A terminal is provided to groundthe terminal card to the 3497A chassis. -hp- part number is 03497-641 11. SeeFigure 170 for schematic.Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com