Part 2

546 Plug-ln Assembly Configuration1 3497Al3498A CHANNEL CAPACITY 1I ASSEMBLY 1 3497A ONLY 1 3497A + 3498As I# SLOTS#CHANNELSMAX #3498As#SLOTSANALOGDIGITAL551008058508510001360For example,to achieve maximum channel capacity, you could configureyour system as shown, with analog assemblies in the 3497A and in thefirst 45 slots of 3498As and digital assemblies in the remaining 85 slots.T-5 ANALOG1 ( 10 ANALOG 150ANALOGASSEMBLIESII10 ANALOG10 ANALOG5 ANALOG 5 DIGITALI 10 DIGITAL I8'5DIGITALASSEMBLIESI10 DIGITAL 1 3498A#13Changing Analog AddressesIf you need to change the analog addresses in a 3498A, use the procedures whichfollow and see Figure 179. Jumpers to modify the analog addresses are located onthe Power Supply-lnguard Decoder board which is located behind the front panel ofthe 3498A.To gain access to this board, first verify that all power sources are removed fromthe 3497Al3498A. Then loosen the fastener on the front panel and swing the panelout. Remove the two screws holding the shield over the board and remove the shield.Then locate the CENTURY and DECADE ADDRESS jumpers as shown in Figure 179.Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com