Fs-3040mfp fs-3140mfp og eng - KYOCERA Document Solutions

Symptom Checkpoints Corrective Actions
Cannot print. Is the machine plugged in? Plug the power cord into an AC
outlet.
Documents are
printed improperly.
While the operation
panel was being used,
the keys locked up
and do not respond
when pressed.
Cannot print with USB
memory.
When displaying an
image sent from the
machine on the PC, an
image size is shrunk
vertically or
horizontally.
USB memory not
recognized.
Vertical streaks
appear on prints.
Is the machine powered on? Turn on the main power switch. 2-6
Is the printer cable
connected?
Was the machine powered
on before the printer cable
was connected?
10-4
Connect the correct printer cable
securely.
Power on the machine after
connecting the printer cable.
Is the print job paused? Press [Resume] (the Left Select
key) to resume printing.
Are the application software
settings at the PC set
properly?
Is the operation panel
locked?
Was the USB memory
formatted with a machine
other than this machine?
Check that the printing system
driver and application software
settings are set properly.
Check the panel lock setting in
COMMAND CENTER and change
the setting if necessary.
Format the USB memory with this
machine.
Is the USB host blocked? Select Unblock in the USB host
settings.
Check that the USB memory
is securely plugged into the
machine.
Have you selected
200×100dpi Normal or
200×400dpi Super Fine for
the scan resolution?
Check that the USB memory
is securely plugged into the
machine.
Troubleshooting
—
2-5
2-5
2-6
7-18
—
— —
Select a scan resolution other than
200×100dpi Normal or 200×400dpi
Super Fine when sending an
image.
— —
Is the USB host blocked? Select Unblock in the USB host
settings.
The inside of the machine
may be dirty.
Check the toner container and if
necessary replace.
COMMAND
CENTER
Operation
Guide
8-143
5-14
8-143
9-4
Refresh drum. 8-99
Reference
Page