UNIX AND LINUX INSTALLATION RELEASE 11 - Sonnet Software

Chapter 2 UNIX Installation12 When you have completed these instructions, go to Step 4: Creating theLicense on page 25 and continue.Step 3c:Installing from a CD on HP-UXTo load in the software:1 Login as root.NOTE:The software does not need to be loaded in using root. However, wesuggest that you use root so that users are prevented from changingor removing the Sonnet modules. The software may be loaded underany account.2 Insert the Sonnet CD-ROM into your CD-ROM drive.You will need to have the directory “/cdrom” on your system beforemounting the CD-ROM. To check to see if the directory “/cdrom” existstype:ls -ld /cdromIf you receive an error message, type the following command to createthe directory:mkdir /cdromTo read in the software, you must first mount the CD-ROM. Anexample of an appropriate command for a HP platform is shown below.If you are not sure of the command, see the System Administrator./etc/mount -r -F cdfs /dev/dsk/c0t2d0 /cdrom3 You should create the directory in which you wish to place the Sonnetsoftware; this will be referred to as the Sonnet directory. For example, ifyou wish to place the software in “/home/sonnet”, then you wouldneed to type the following:mkdir /home/sonnetYou may place the software in any directory you wish; just substituteyour pathname in place of “/home/sonnet”.4 Go to the “cdrom” directory. Type:23