CJ2 CPU Unit Software User's Manual - CIP ETI

8 I/O Allocations and Unit Settings8-2 Setting CPU Bus Units and SpecialI/O Units8-2-1 Setting ParametersThe CX-Programmer can be used to set parameters in the DM Area and CIO Area words allocated toCJ-series CPU Bus Units and Special I/O Units and to set the CPU Bus Unit Setup for EtherNet Units.The I/O Table Window is used in the CX-Programmer.The settings can be made either online or offline. If they are made offline, you must go online to transferthem.This section describes an example of editing the I/O tables and making settings for CPU Bus Units andSpecial I/O Units after creating the I/O tables and transferring them from the CPU Unit to the I/O TableWindow. The procedure is the same as when registering CPU Bus Units and Special I/O Units to theI/O tables offline and then editing the settings for CPU Bus Units and Special I/O Units.1 Connect the CX-Programmer online and open the I/O Table Window.2 Select Options − Transfer from the PLC from the I/O Table Window menu. The Transfer from thePLC Dialog Box will be displayed as shown in the following figure.At this point, the I/O Table and SIO Unit Parameters Options can be selected.8-20 CJ2 CPU Unit Software User’s Manual