PDF version - ARM Information Center

More documents

Recommendations

Info

Programmer’s Reference for the VE RTSMsNoteThe VE RTSM implementation of memory does not require programming the memorycontroller with the correct values.This means you must ensure that the memory controller is set up properly if you run anapplication on actual hardware. If this is not done, applications that run on a RTSM might failon actual hardware.ARM DUI 0575A Copyright © 2011 ARM. All rights reserved. 3-4ID051811Non-Confidential
Programmer’s Reference for the VE RTSMs3.2 VE model configuration parametersThe Real-Time System Models for the VE reference system have parameters that can be definedat run time.Parameters that can be modified only at model build time, or that are not normally modified bythe user in the equivalent hardware system, are not discussed.See the following sections for details of the model parameter sets:• Motherboard peripheral parameters• Motherboard virtual component parameters on page 3-8• RTSM_VE_Cortex-A15MPx1, RTSM_VE_Cortex-A15MPx2 andRTSM_VE_Cortex-A15MPx4 coretile parameters on page 3-10• RTSM_VE_Cortex-A9 coretile parameters on page 3-12• RTSM_VE_Cortex-R5_MPx1 and RTSM_VE_Cortex-R5_MPx2 coretile parameters onpage 3-14• ARMv7A-AEM on page 3-17.3.2.1 Motherboard peripheral parametersThis section describes the peripheral parameters that you can change on the motherboard. Itcontains:• Color LCD controller parameters• Ethernet parameters• System controller parameters on page 3-6• VE system register block parameters on page 3-6• UART parameters on page 3-7• Watchdog parameters on page 3-7.Color LCD controller parametersTable 3-4 lists the Color LCD Controller instantiation-time parameters that you can changewhen the model is started.The syntax to use in a configuration file or on the command line is:motherboard.pl111_clcd.parameter=valueTable 3-4 Color LCD controller configuration parametersParameter Description Type Values Defaultpixel_double_limitThe threshold in horizontal pixels belowwhich pixels sent to the frame-buffer aredoubled in size in both dimensions.integer - 0x12CEthernet parametersTable 3-5 on page 3-6 lists the Ethernet instantiation-time parameters that you can change whenthe model is started.The syntax to use in a configuration file or on the command line is:ARM DUI 0575A Copyright © 2011 ARM. All rights reserved. 3-5ID051811Non-Confidential
Page 1 and 2: Real-Time System ModelVersion 1.0Re
Page 3 and 4: ContentsReal-Time System Model Refe
Page 5 and 6: PrefaceThis preface introduces the
Page 7 and 8: Prefaceboldmonospacemonospacemonosp
Page 9 and 10: PrefaceFeedbackARM welcomes feedbac
Page 11 and 12: Introduction1.1 Introduction to sys
Page 13 and 14: Introduction• ARMv7A-AEM on page
Page 15 and 16: IntroductionA complete model implem
Page 17 and 18: Getting Started with Real-Time Syst
Page 33 and 34: Chapter 3Programmer’s Reference f
Page 35: Programmer’s Reference for the VE
Page 39 and 40: Programmer’s Reference for the VE
Page 61 and 62: Programmer’s Reference for the MP
Page 69 and 70: GlossaryThis glossary lists abbrevi
Page 71: GlossaryVEVersatile Express. A hard

PDF version - ARM Information Center

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?