PDF version - ARM Information Center

Programmer’s Reference for the VE RTSMsmotherboard.sp805_wdog.parameter=valueTable 3-9 Watchdog configuration parametersParameter Description Type Values Defaultsimhalt Halt on reset boolean true or false false3.2.2 Motherboard virtual component parametersThis section describes the virtual component parameters that you can change on themotherboard. It contains:• FLASH loader parameters• Host bridge parameters• MultiMedia Card parameters on page 3-9• Terminal parameters on page 3-9• VFS2 parameters on page 3-9• Visualization parameters on page 3-10.FLASH loader parametersTable 3-10 lists the FLASH loader instantiation-time parameters that you can change when themodel is started.The syntax to use in a configuration file or on the command line is:motherboard.flashloaderx.parameter=valuewhere x is the FLASH identifier 0 or 1.Table 3-10 FLASH loader configuration parametersParameter Description Type Values DefaultfnamePath to the host file used to initializeFLASH contents when the model starts.The file can be gzip compressed.stringValidfilename[emptystring]fnameWritePath to the host file used to save FLASHcontents when the model exits.stringValidfilename[emptystring]Host bridge parametersTable 3-11 lists the host bridge instantiation-time parameters that you can change when themodel is started.The syntax to use in a configuration file or on the command line is:motherboard.hostbridge.parameter=valueTable 3-11 Host bridge configuration parametersParameter Description Type Values DefaultinterfaceName Host interface identifier string Valid string ARM0For information on networking, see the sections on setting-up a network connection in the FastModels User Guide.ARM DUI 0575A Copyright © 2011 ARM. All rights reserved. 3-8ID051811Non-Confidential